Tin tức mới nhất

  • Ngành Marketing
    Marketing là ngành giữ vai trò rất quan trọng trong hoạt động kinh doanh của hầu hết mọi tổ chức kinh doanh trên thế giới. Hiệu quả của hoạt động bán hàng chịu ảnh hưởng lớn từ marketing và nó còn chi phối cả hoạt động của doanh nghiệp trong hiện tại và tương lai. Những công ty quảng cáo, truyền thông tại Việt Nam đang ngày càng nhiều. Các doanh nghiệp muốn bán được nhiều hàng hóa và sản phẩm thì một phần không thể thiếu chính là cách các nhà đầu tư đưa sản phẩm đến tay người tiêu dùng để có thể cạnh tranh với nhiều đối thủ. Vì vậy yêu cầu về một đội ngũ chuyên tiếp xúc với khách hàng, có những sáng tạo để tiêu thụ được sản phẩm là hết sức quan trọng.
  • Ngành Quản trị Kinh doanh
    Ngành Quản trị kinh doanh đào tạo ra những sinh viên năng động và linh hoạt để phù hợp làm việc trong nhiều lĩnh vực kinh doanh như kế toán, tài chính, marketing, logistic. Trong xu thế toàn cầu hóa hiện tại, nhân lực quản trị các kênh bán hàng, doanh nghiệp với tư duy đổi mới và kỹ năng chuyên môn tốt đang rất cần cho nền kinh tế.
  • Nguyễn Quốc Ý và Nguyễn Tuấn Việt Characterizing the induced flow through the cavity of a wall solar chimney under the effects of the opening heights
    Abstract: Using solar chimneys in buildings can enhance the thermal insulation of the building envelope and provide sufficient ventilation and cooling. The performance of a solar chimney is strongly affected by its configurational factors. This work examines the effects of the opening heights on the flow field in the cavity of a wall solar chimney with a Computational Fluid Dynamics (CFD) model. Both cases of equal and unequal opening areas were considered. The results show that the induced flow rate increases with the opening height and gradually becomes constant as the opening height is about 2.0–3.0 and 5.0–6.0 times the air gap for heating the left wall (HLW) and the right wall (HRW) of the air cavity, respectively. Particularly, using equal inlet and outlet heights that are equal to the air gap reduces the flow rate of 27% for HLW and 85% for HRW compared to the maximum ones. The optimal design of a wall solar chimney to achieve maximum flow rate is proposed for two cases of heating, that is, (a) for HLW, equal opening heights which are twice the air gap, and (b) for RHW, the inlet height equal to the air gap, and the outlet height equal to five times the air gap.
  • Nguyễn Quốc Ý, Nguyễn Tuấn Việt, Trần Thanh Long, John C. Wells CFD Analysis of Different Ventilation Strategies for a Room with a Heated Wall
    Abstract: Solar chimneys can help to reduce solar heat gain on a building envelope and to enhance natural ventilation. In this work, we proposed three configurations of two solar chimneys combined with a heated wall for the natural ventilation of a room: (I) the chimneys are connected serially, (II) the chimneys are parallel and exhaust air at two separate outlets, and (III) the chimneys are parallel, but the outlets are combined. The airflow rate achieved with each configuration was predicted with a Computational Fluid Dynamics model. The results show the effects of the heat flux in each channel and the geometries of the channels. Configuration (II) shows the highest flow rate. Particularly, the proposed configurations enhance the flow rate significantly and up to 40% when compared to the typical setup with a single channel solar chimney. The findings offer a novel design option for building façades for reducing solar heat gain and enhancing natural ventilation.
  • Nguyễn Quốc Ý Performance of a wall solar chimney at different opening areas
    Abstract: This paper reports effects of the opening areas of a wall solar chimney on the flow rate and heat transfer performance. Previous studies showed that the opening size is among the most important factors which affect the performance of solar chimneys. However, such effects for a wall-attached solar chimney whose openings are vertical have not been reported in the literature. The performance of a wall solar chimney was simulated with a Computational Fluid Dynamics (CFD) tool in this paper. The induced flow rate and Nusselt number were compared for various inlet and outlet areas. The results show that the most influencing factor is the ratio of the inlet and the outlet areas. Particularly, the heat transfer coefficient and flow rate approach constants as the inlet or outlet area is above twice the channel gap. The findings suggest that the optimum opening height is equal to the channel gap.